standby_mode
(boolean
)
Specifies whether to start the PostgreSQL server as
a standby. If this parameter is on
, the server will
not stop recovery when the end of archived WAL is reached, but
will keep trying to continue recovery by fetching new WAL segments
using restore_command
and/or by connecting to the primary server as specified by the
primary_conninfo
setting.
primary_conninfo
(string
)
Specifies a connection string to be used for the standby server to connect with the primary. This string is in the format described in Section 33.1.1. If any option is unspecified in this string, then the corresponding environment variable (see Section 33.14) is checked. If the environment variable is not set either, then defaults are used.
The connection string should specify the host name (or address)
of the primary server, as well as the port number if it is not
the same as the standby server's default.
Also specify a user name corresponding to a suitably-privileged role
on the primary (see
Section 26.2.5.1).
A password needs to be provided too, if the primary demands password
authentication. It can be provided in the
primary_conninfo
string, or in a separate
~/.pgpass
file on the standby server (use
replication
as the database name).
Do not specify a database name in the
primary_conninfo
string.
This setting has no effect if standby_mode
is off
.
primary_slot_name
(string
)
Optionally specifies an existing replication slot to be used when
connecting to the primary via streaming replication to control
resource removal on the upstream node
(see Section 26.2.6).
This setting has no effect if primary_conninfo
is not
set.
trigger_file
(string
)
Specifies a trigger file whose presence ends recovery in the
standby. Even if this value is not set, you can still promote
the standby using pg_ctl promote
.
This setting has no effect if standby_mode
is off
.
recovery_min_apply_delay
(integer
)
By default, a standby server restores WAL records from the
primary as soon as possible. It may be useful to have a time-delayed
copy of the data, offering opportunities to correct data loss errors.
This parameter allows you to delay recovery by a fixed period of time,
measured in milliseconds if no unit is specified. For example, if
you set this parameter to 5min
, the standby will
replay each transaction commit only when the system time on the standby
is at least five minutes past the commit time reported by the master.
It is possible that the replication delay between servers exceeds the value of this parameter, in which case no delay is added. Note that the delay is calculated between the WAL time stamp as written on master and the current time on the standby. Delays in transfer because of network lag or cascading replication configurations may reduce the actual wait time significantly. If the system clocks on master and standby are not synchronized, this may lead to recovery applying records earlier than expected; but that is not a major issue because useful settings of this parameter are much larger than typical time deviations between servers.
The delay occurs only on WAL records for transaction commits. Other records are replayed as quickly as possible, which is not a problem because MVCC visibility rules ensure their effects are not visible until the corresponding commit record is applied.
The delay occurs once the database in recovery has reached a consistent state, until the standby is promoted or triggered. After that the standby will end recovery without further waiting.
This parameter is intended for use with streaming replication deployments;
however, if the parameter is specified it will be honored in all cases.
hot_standby_feedback
will be delayed by use of this feature
which could lead to bloat on the master; use both together with care.
Synchronous replication is affected by this setting when synchronous_commit
is set to remote_apply
; every COMMIT
will need to wait to be applied.